User`s guide

The Terminal Server
________________________________________________________________
48 TCP/IP AXEL Platine Terminal
This chapter provides the information needed to use serial terminals attached to
a Platine terminal.
The AX3000 provides two bi-directional auxiliary serial ports. Various serial
peripherals can be attached to these serial ports: bar code readers, printers,
scales, etc.
With the embedded AX3000 Terminal Server, serial terminals can also be
attached. These serial terminals are automatically controlled by the embedded
telnet service. No additional software is needed.
This feature must be declared through the two AX3000 set-up procedures:
Terminal Set-Up and TCP/IP Set-Up.
6.1 - TERMINAL SET-UP
This set-up is used to define the network service associated with the auxiliary
ports (lpd, rcmd, rtelnet, etc), and to configure the serial ports.
Press <Ctrl><Alt><Esc> from an active session to enter Terminal Set-Up.
6.1.1 - Select the Network Service
Press <F5> to enter the 'Terminal Mode' set-up screen. The 2 following fields
allow a network service to be associated with the serial ports:
- AUX1 Port Service,
- AUX2 Port Service.