User`s guide

Setting the Configuration
________________________________________________________________
12 TCP/IP AXEL Platine Terminal
RARP protocol on the AXEL Terminal:
If the AX3000 IP address has not been set (it has the value 0.0.0.0) the
following screen will be displayed when the AX3000 is turned on:
F I R S T I N S T A L L A T I O N
Press <Ctrl><Alt><*> to enter set-up
or
press <spacebar> to search for the AX3000 IP address (RARP protocol)
AX3000 TCP/IP Terminal Base
TB105.3.M55.FR.9701.a
00:A0:34:xx:xx:xx
Pressing <spacebar> will automatically trigger the RARP protocol. The AX3000
sends 8 RARP requests, at intervals of 3 seconds. There are two possible
results:
A host replies:
The RARP protocol is stopped, the AX3000 IP address is automatically set and
the following message is displayed:
AX3000 IP found: xxx.xxx.xxx.xxx
Press any key to continue.
No reply is received after 8 requests:
The
following message is displayed:
AX3000 IP not found
.
In this case there are two options for setting the AX3000 IP address:
- through TCP/IP Set-Up or
- configure a RARP server, then power-cycle the AX3000.