User`s guide

Setting the Configuration
________________________________________________________________
8 TCP/IP AXEL Platine Terminal
This chapter provides the general information needed to install and configure
TCP/IP AX3000 Platine terminals on an Ethernet network.
The main steps to install a Platine terminal are:
- assign an Internet address matching the network topology,
- define the network environment accessible from this Platine terminal
(Telnet hosts, routers, etc),
- associate a host with each Platine terminal session,
- set terminal parameters (emulation, function keys, etc) for each available
Platine terminal session.
The first three steps use the terminal’s TCP/IP Set-Up, as described below. The
fourth step is invoked from Terminal Set-Up.
Note: the following pages describe the installation and use of TCP/IP
Platine terminals. This procedure assumes that a UNIX TCP/IP package
has been correctly installed.
2.1 - TCP/IP SET-UP
The following command sequence is used to enter TCP/IP Set-Up:
Note: use the <
> key on the numeric keypad.