User`s guide

Downloading Firmware
________________________________________________________________
116 TCP/IP AXEL Platine Terminal
An automatic connection to the tftp host will then be established in order to
download the firmware file (see previous chapter).
If any problems occur, refer to the next chapter.
11.4 - IN CASE OF PROBLEMS
This chapter discusses possible problems. The error list is not exhaustive ; if an
unlisted error occurs, please contact your AXEL distributor.
After an error, the AX3000 should be power-cycled.
11.4.1 - Bootp Stage
If an error occurs, the following message is displayed on the AX3000 monitor:
Bootp errno: xxx
-
xxx
is the error number.
Possible errors:
0: Ethernet board not responding.
1: no response to the bootp broadcast request (the bootp host is
unreachable or not correctly set-up).
Note: a bootp error does not erase the AX3000 firmware.
11.4.2 - Tftp Stage
A tftp error message can originate from either the tftp host or the AX3000.
Depending on the error, the AX3000 firmware may be erased. If this happens
the firmware downloading will be automatically run (bootp+tftp protocol) the
next time the AX3000 is power-cycled.
Tftp Host Errors:
tftp errno: xxx label