User`s guide

Downloading Firmware
________________________________________________________________
TCP/IP AXEL Platine Terminal
115
The message '
Downloading in progress...
' will be displayed on the
operator console if downloading can be performed (AX3000 and tftp host
reachable, firmware file found, etc.). A few seconds later, the target AX3000
will be automatically reset and the new firmware will be enabled.
Note: during the downloading operation, additional messages will be displayed
on the target AX3000 (see Section 11.3.2).
Check for correct completion of the downloading operation with the command:
'
rcmd ax_version
'.
# rcmd ax3001 ax_version <CR>
The firmware version is displayed on the operator’s console. For example:
FK3.BV1.1a/TCP.UK.9701.a
11.3.2 - Downloading Through Set-Up
Enter TCP/IP Set-Up (
<Ctrl><Alt>< >
) and select the '
Flash'
menu.
Within this menu, select the '
Download (bootp+tftp)
' item.
Answer 'y' (yes) to the '
Download?
' question to start the download operation.
The following message will be displayed on the AX3000 monitor:
AX BOOTP V1.1a
Flash Key 3
If a response is received to the bootp broadcast request, information about the
firmware file location will be displayed:
AX3000 IP: 192.168.1.242
bootp server name: vangogh
bootp relay IP: 0.0.0.0
tftp server IP: 192.1.1.254
file name: /axel/firm9645
tftp router IP: 192.168.1.252