User`s guide

Downloading Firmware
________________________________________________________________
110 TCP/IP AXEL Platine Terminal
Example 1:
# rcmd ax3001 ax_download /usr/firm 192.168.1.249 <CR>
Example 2: a router is used
# rcmd ax3002 ax_download /usr/firm vangogh 192.168.1.249 <CR>
Possible errors (displayed on the operator’s console):
-
ERR 105: invalid rcmd command
: incorrect keyword (check the
syntax).
-
ERR 108: invalid number of parameters
: bad parameter
number (2 or 3 parameters are required after the keyword).
-
ERR 109: invalid file length
: the filename is too long (more
than 31 characters).
-
ERR 110: invalid server
: the tftp host name is unknown (not listed
in the AX3000 Set-Up).
-
ERR 111: invalid router
: the router name is unknown (not listed in
the AX3000 Set-Up).
Note: other errors messages can also be displayed (connection time-out for
example). Refer to UNIX manuals.
The message '
Downloading in progress...
' is displayed on the
operator’s console if the download can be performed (AX3000 and tftp host
reachable, firmware file found, etc.). A few seconds later, the target AX3000 is
automatically reset and the new firmware is enabled.
Note: during the downloading operation, various messages are displayed on
the target AX3000 (see Section 11.2.2).
To check the downloading operation has been correctly completed, use the
'
rcmd ax_version
' command:
# rcmd ax3001 ax_version <CR>
The version of the newly installed firmware is displayed on the operator
console. For example:
FK3.BV1.1a/TCP.UK.9701.a