Installation Guide

Responding to Activator IDs

The Receiver will only output Tag data via the serial port if it

contains a valid Activator ID.

By default, The Network Receiver accepts Tag data from

Activators with the following IDs:

0 3 13 14 21 22

24 27 33 34 44 47

52 55 57 58 69 70

72 75 80 83 93 94

100 103 105 106 113 114

124 127 254 255

Figure 5 Default Activator IDs

Editing Activator IDs within the Receiver

Use the following commands to add, delete and reset the

Activator ID numbers within the Receiver:

Command Action

<number>- Delete unwanted ID(s) from the Receiver’s list

37c Remove all accepted Activator IDs

(Receiver will still pass default ID 127)

<number>+ Add an Activator ID

34c Reset the list to the valid Activator ID numbers

When editing the Activator IDs within the Receiver, you may

observe the following error codes.

Code Reason

04 Trying to delete an ID that has not been

programmed

03 Trying to delete all IDs. Must be at least one ID.

02 Trying to enter more than 34 IDs – the max.

(Delete some Activator IDs on the list to make room)

01 Duplicate entry