Operating instructions

MAINTENANCE
86324160 AXCESS 03/23/09
4-1
! CAUTION
Use only genuine replacement floor
pads to ensure performance,
longevity and safety.
FILTERS
When the orange bag full indicator is showing, airflow is
reduced. This could be because the filter bag is full, the
filters clogged, or there may be a blockage (see Removing
blockages).
CHANGING THE FILTER BAG
To remove the filter bag , open the latch on the side of the
bag housing. Close the filter bag with the sealing cap and
lift it out. The procedure to replace the bag is illustrated on
the front of each bag. You cannot close the bag housing if
the bag is fitted incorrectly.
MOTOR PROTECTION FILTER AND EXHAUST
FILTER
The motor protection filter is only accessible by removing
the filter bag. Lift the motor protection filter up by the
bracket. When replacing the motor protection filter make
sure that it is pressed in position tightly. The motor
protection filter should be changed when it is dirty or at the
latest when you have used 20 filter bags. Change the
exhaust filter at the same time as the motor protection
filter. To do this, carefully remove the filter retaining rings
and put them to the side. Next pull the enforcement strips
of the exhaust filter out of the housing slot and remove the
exhaust filter from the housing. When reassembling,
please ensure the exhaust filter is fitted correctly in the
housing slots and the filter retaining rings are installed
correctly. Otherwise the filter will be ineffective.
NOTE: Use only genuine replacement bags and filters to
ensure effectiveness and safety. Do not wash any filters.