User's Manual Part 1

· Is the building structure where the equipment is

to be placed properly prepared ? Listed below are

systems and specifications that need to be opera-

tional prior to installation of transmission equip-

ment.

Heating and Air Conditioning

Electrical Systems

Building Structure

Antenna

Satellite Dish

Transmission Line

· Have all the systems listed above been tested and/

or inspected ?

· Is the space provided for equipment racks suffi-

cient ? Will an additional devices that extend out

above or to the side of the unit have sufficient

clearance space ? Refer to the system custom rack-

ing plan for detailed specifications.

Input Connections for Analog Operation:

Connect the Baseband Video Signal Input to J2, a 75 ohm BNC

connector located on the rear of the tray.

Connect either the Baseband Balanced Mono Audio Signal Input

to J11, a 600 ohm 3 terminal block connector located on the

rear of the tray, or the Unbalanced Composite Stereo Audio Sig-

nal Input to J3, a 75 ohm BNC connector also located on the rear

of the tray.

Input Connections for Digital Operation:

Connect the Digital IF Signal Input to J14, a 75 ohm BNC connec-

tor located on the rear of the tray.

NOTE: For connections using Scientific Atlanta and Pac-Mono

scrambling, refer to that section which follows.

Output Connections for Typical Operation:

Connect RF Output of the tray at J8, a 50 ohm N connector,

located on the rear of the tray, to the designated Channel Com-

biner or Spectral Shaping Filter for your system.

Check that CB1 the AC circuit breaker, located on the rear of the

tray near the AC input Jack, is Off.

Connect the AC power cord the J1 on the rear of the tray and

the plug end to an appropriate AC outlet.