User's Manual Part 1

OPERATION

Initial Turn On

Once all connections have been made and the unit has been installed, the process of turning

on the equipment can begin. First verify that AC power is present and connected to each

transmitter. Verify all cables are properly connected and the correct type. Once all of these

things are done, the unit is ready to be turned on following the procedures below.

Turn on the main AC power source that supplies the

entire system. Turn on the AC circuit breaker (CB1) on the

back of each unit.

Verify that each unit is showing the display as indicated

in the diagram. (Note: Some models may display ADC

TELECOMMUNICATIONS).

When the transmitter is in operate mode, the STB menu ap

pears. In standby mode, the OPR menu appears. Press the

NXT key after each menu to continue through the sequence

that follows.

AXCERA V 2.5

LLC

MODEL: 5724

RF CHANNEL: A1

STB STS PRV

VERSION 2.5

SCADA ADDRESS: 32

STB STS PRV

If the SCADA option is selected, the unit will display the

version number and SCADA address.

Next, the unit will display percentage output power.

OUTPUT PWR 75%

0 50 100

STB STS PRV

REFLECTED PWR 10%

0 50 100

STB STS PRV

Percentage reflected power screen.

EXT OUTPUT PWR 75%

0 50 100

STB STS PRV

External amplifier output power (if external amp

present)