User's Manual Part 1

Rear Panel

The rear panel of the 5720 features remote control inputs and outputs, visual and aural IF

inputs and outputs, visual and aural analog inputs, 10MHz reference input, and access to

SCADA communications if that is a selected option. AC connections as well as a cooling fan and

circuit breaker are also located on the back of the unit as pictured below.

Connection Label Description Connector Type / Impedance Frequency

J1 AC AC input to the unit IEC320 50 or 60 Hz

J2 Video I/P Video Signal Input BNC 75 ohms baseband

J3 Comp Audio I/P Composite audio input BNC 75 ohms 50Hz-100KHz

J4 Visual IF O/P Visual IF signal output BNC 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J5 Visual IF I/P Visual IF signal input BNC 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J6 Aural IF O/P Aural IF signal output BNC 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J7 Aural IF I/P Aural IF signal input BNC 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J8 RF O/P RF signal output N / 50 ohms 2.1-2.7 GHz

J9 Combined IF O/P Combined IF output BNC 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J10 IF CW I/P IF contionious wave input BNC 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J11 Baseband Baseband audio input 3 position terminal block baseband

600 ohms

J12 Control Control Signals D connector 37 position female N/A

J13 Remote Remote signals D connector 25 position male N/A

J14 IF I/P IF input signal BNC / 75 ohms 38.9-45.75 MHz analog

36 or 44 MHz digital

J15 SCADA Comm SCADA port RJ-45 N/A

J16 SCADA Comm SCADA port RJ-45 N/A

J17 EXT 10MHz Ref I/P 10 MHz reference input BNC / 50 ohms 10 MHz

CB1 AC Circuit breaker N/A N/A