Installation Guide

Aligning flare on fender, press inward on the flare to line up

the flare mounting holes with the clips on the Inner Bracket.

Install 3 supplied Truss-Head Screws through the flare and

into the inner piece. Do not tighten.

Still pressing flare to fender, reinstall 2 remaining factory

screws removed in Step 4. Apply pressure to flare towards

vehicle body at each fastening point and tighten all

fasteners.

SECTION 3: FRONT FLARE INSTALLATION

Install 3 Short “U” Clips onto the Inner Bracket as shown.

NOTE: Driver’s side Inner Bracket is marked with an “LH”

and the passenger’s side Inner Bracket is marked with an

“RH”.

Remove 6 factory screws with a 7/32” socket wrench.

Retain screws for reinstallation. NOTE: For Platinum

Edition, there are additional screws to be removed and

retained.

Line up holes in the Inner Bracket with the 4-most upper

factory holes in wheel well.

Using a 7/32” socket, reinstall 4 factory screws through the

Inner Bracket.