Installation Guide

SECTION 1: EDGE TRIM INSTALLATION
A) Peel 2-3 inches of red vinyl backing away
from supplied edge trim tape. Applying the
adhesive side of the edge trim to the inner
side of the flare, affix the edge trim to the
top edge of the flare (the portion that comes
in contact with the side of the vehicle).
Press edge trim into place along the top
edge of the flare in one-foot increments,
pulling red vinyl backing free as you
continue to work your way around the top
edge of the flare. Trim edge trim flush with
ends of flare.
SECTION 2: POCKET HARDWARE INSTALLATION
Install a supplied SS Pocket Washer onto each SS Pocket
Torx Bolt.
Insert each Bolt/Washer combination through pocket holes
in flare, Bolt head and Washer on the outside.
1
2
Place a supplied Pocket Nylock Nut over the end of each
bolt and tighten using a 1/2” wrench for the Nut and the
supplied T-45 Torx Bit for the Bolt. Repeat for all pockets.
3
A