User`s manual

Digital Display Manual
9
3.1 Current Conditions
By default, all values displayed by the digital unit are "real-time" or current
conditions (values are updated every one second). What you see displayed is
what is happening at the time. The following paragraphs will describe each value
individually.
Time/Date
The time and date are shown in the top, center region of the Digital Display. By
default, the display is set to the current time in 24 hour format. The date is
displayed in "month.day" format, e.g., if the date shown is "2.15" then the date is
February 15th. When the date is being displayed, neither of the AM/PM indicator
lights are illuminated.
Pressing the "Select" button to the left of the time/date box set the display in
cycle mode where it will continuously rotate between the time and the date.
Pressing the "Select" button again will cause the display to be fixed on the value
it was displaying at the time.
If the time and/or date indicated is incorrect, please call WeatherBug Weather
Station Technical Support at [phone] to have Technical Support remotely
set the time and date. Please note that the unit will automatically correct itself for
Daylight Savings Time.
Humidity
The relative humidity reading is located just below the time/date. The units of
relative humidity are percent (%). To the right the humidity box are trend arrows
in the form of upward and downward pointing triangles. If the upward pointing
triangle is illuminated then the humidity is rising (increasing). If the downward
pointing triangle is illuminated then the humidity is falling (decreasing). If neither
of the triangles are illuminated then the humidity is steady (not changing). To
view rates of change and daily minimum and maximum values for relative
humidity, refer to sections 3.3 and 3.4 of this manual.
Barometer
The barometric pressure reading is located just below the relative humidity box.
Barometric pressure can be displayed in both the English units of inches of
Mercury ("Hg) and the Metric units of millibars (mbar). Refer to section 3.2 of this
manual to change the display units.