American Weigh Scales LS-110 User Manual LS-110 (110lb x 0.2lb) Copyright © 2010 American Weigh Scales, Inc. All rights reserved. Rev. 2.
LS-110 Manual Thank you for purchasing the American Weigh LS-110 luggage scale. Please read all operating instructions carefully before use. Scales are precision measuring devices and should always be handled with proper care. To ensure years of reliable service, keep these simple tips in mind: • • • • • • • • • • Do not exceed the scale’s maximum capacity. Overloading your scale can permanently damage it! Avoid exposure to extreme heat or cold. Scales perform best at normal room temperature.
I. Part List 1. Scale 2. Weighing Tray 3. AAA Batteries (x2) II. Key Description ON/OFF TARE Key ON/OFF Lock III. Battery Installation 1. Before using the scale for the first time, check the battery compartment and remove any plastic insulation strips or packaging that may be in place to prevent battery drainage during shipping/storage. 2. If you are replacing the batteries, make sure the positive and negative contacts are properly aligned.
LS-110 Manual IV. Operation 1. Set the ON/OFF Lock switch to the ON position and then tap the key to turn the scale on. 2. Once the start-up process completes and the scale goes to zero, you are ready to weigh. 3. Place the quantity to be weighed on the weighing hook. 4. Once the weight has stabilized, a red light will illuminate on the top of the scale and the LCD will display HOLD above the weight. 5. The weight will remain on the display after the item is removed from the hook.
of an empty container or vessel for net weight determination. NOTE: The weight of the container will subtract from the available capacity. 1. Turn on the scale as described in Section IV. 2. Attach your tare item / empty container using the hook and wait for it to stabilize (HOLD will be displayed). 3. Tap the button. “0.0” will be displayed. 4. You can now add items to the container to obtain just the weight of the contents. 5. When the container is removed the weight will be held on the display.
LS-110 Manual eral times until the inner code displays (~2680) 3. Press again. The display will flash “CAL” followed by the required calibration weight (20kg). 4. Add the required weight. The display will show pass and return to normal weighing mode. 5. Remove the weigh and press and hold the turn the scale off. Calibration is complete! key to IX.
XI. Specifications Max. Capacity Readability Min. Capacity Power Dimensions Hook Dimensions Warranty LS-110 110lb / 50kg 0.2lb / 0.1kg 0.6lb / 0.3kg 2 x CR2032 1.4 x 6.0 x 4.8 in. (hook extended) Gap: 1.2in / Throat: 1.
