Operating instructions

2-6

To cancel a regeneration (either manual or automatic):

• Press and hold the SET button and UP buttons simultaneously and hold until the hourglass icon starts ﬂ ashing

(approximately 5 seconds).

• The regeneration is cancelled.

• The camshaft rotates to the treated water position (may take up to 2 min.)

• Hourglass ﬂ ashes while motor runs.

If a second regeneration was programmed (display shows a 2X by the regeneration icon) both regenerations

must be cancelled separately.

WARNING: Cancelling a regeneration may cause undesirable or salty water to go into the plumbing.

Only use this function when absolutely necessary.

CAUTION: If the regeneration cycle is cancelled after the brine draw cycle (C2), check the water level in

the brine tank. It must be reﬁ lled to the proper level.

MANUAL REGENERATION

Action Key Duration Display

Regen at next time of regen REGEN P/R Recycle icon ﬂ ashes

Cancel regen REGEN P/R when recycle Recycle icon disappears

icon is ﬂ ashing

Immediate regen REGEN 5 sec. Recycle icon appears

Immediate double regen REGEN 5 sec. when X2 icon appears

immediate manual

regen has started

The controller can be manually instructed to perform a regeneration. There are two (2) choices: The controller

will perform a delayed regeneration at the next time of regeneration (ex. 2:00 AM that night), or regenerate im-

mediately.

For a delayed regeneration (at the next set time of regeneration):

• Push the REGEN button once. The recycle symbol will be ﬂ ashing on the display. Push the REGEN button

again to cancel.

For an immediate regeneration:

• Push and hold the REGEN button for ﬁ ve (5) seconds. The display will show the regeneration symbol. The

camshaft will start rotating to cycle C1.

For an immediate, double regeneration:

• After an immediate manual regeneration has begun, and the camshaft has rotated to cycle C1, you can initiate

a second immediate manual regeneration.

• Press and hold the REGEN button for 5 seconds once the camshaft has begun cycle C1.

• The display will show a x2 icon indication that a second manual regeneration will occur after the current regen-

eration is completed.