Operating instructions

6-3

PROBLEM CAUSE SOLUTION

16.Control will not regen- A. If water ﬂ ow display is not operative, refer A. Same as Problem 10.

erate automatically but to Problem 10.

will regenerate when B. Defective circuit board. B. Replace timer.

button is pushed. C. Incorrect hardness and capacity settings. C. Set to correct values.

17.Run out of soft water A. Improper regeneration. A. Repeat regeneration, making certain that

between regenerations correct salt dosage is used.

B. Incorrect salt settings. B. Set control to proper level. See

Speciﬁ cations.

C. Incorrect hardness. C. Set to correct values.

D. Water hardness has increased. D. Set hardness to new value.

E. Restricted meter turbine rotation due to E. Remove water housing, free up turbine

foreign material in meter. and ﬂ ush with clean water. Turbine

should spin freely; if not, replace meter.