Operating instructions

4-1
IMPORTANT: SECTION 4: SERVICE INSTRUCTIONS & MAINTENANCE
VALVE SERVICE
COVER
The cover provides protection for the controller, wiring, and other components. This cover will be removed for
most service and maintenacnce.
When installed, the cover provides NEMA 3 water protection. This protects from falling water up to 30 degrees
from vertical.
To remove cover:
1) Grasp side edges toward rear of the valve.
2) Pull outwards until the slots in the cover clears the projections on the top plate.
3) Lift up on the rear and pull forward to clear the control module.
To install cover:
1) Position cover to be low in front and under the bottom edge of the control module.
2) The cover will hook on the bottom of the controller and drop down over the camshaft.
3) To fi nish, grasp the side edges and pull outward to clear the projections on the top plate.
4) Drop down until the cover snaps in place.
ELECTRONIC CONTROL MODULE
The purpose of the electronic control module is to control the regeneration cycle. The control module has sev-
eral variations. When replacing the controller, use the same model or some functions may not work. This is an
electronic controller that is programmable and uses input/output signals.
To remove control module:
1) Disconnect power to the unit.
2) Remove valve cover.
3) Press trip lever to release module from top plate.
4) Pivot the top forward and up.
5) Remove any wire connections. Wire connections have a locking tab that must be squeezed before
removing.
NOTE: There is no need to label the wires. The keyed connectors will only plug back into one site.
To install control module:
1) Be sure the power is disconnected.
2) Check model.