Operating instructions

2-8

While pressing the SET button, press the UP arrow to advance to the next cycle. Continue to advance through

each cycle until you have reached cycle C8 (Reﬁ ll).

NOTE: As you advance through each cycle there will be a slight delay before you can advance to the next

cycle. The hourglass icon will light while the camshaft is indexing. There may be a puase at cycle C4 (Sys-

tem Pause). This cycle allows the water/air pressure to equalize on each side of the valve discs before

moving on. The hourglass will not be visible indicating that the system is paused.

C) With the water supply completely open, when you arrive at cycle C8 (Reﬁ ll), the controller will direct

water down through the line to the brine tank. let the water ﬂ ow through the line until all air bubbles

have been purged from the line.

D) Do not let the water ﬂ ow down the line to the tank for more than one to two minutes, or the

tank may overﬁ ll.

E) Once the air is purged from the line, press the SET button and the UP button simultaneously to

advance to cycle C0 (Treated Water) position.

7) Draw water from the brine tank.

Action Key Duration Display

Advance to C1 REGEN 5 Sec REGEN icon steady, C1

and time remaining

Advance to C2 SET and UP P/R REGEN icon steady, C2

and time remaining.

A) From the treated water position (cycle C0), advance the valve to the brine draw position. Hold the

REGEN button down for 5 seconds.

The controller will begin a manual regen, and advance the control valve to the cycle C1 (Backwash).

Press the SET and UP button to advance to cycle C2 (Draw).

B) With the controller in this position, check to see that the water in the brine tank is being drawn out of the

tank. The water level in the tank should recede very slowly.

C) Observe the water being drawn from the tank for at least three minutes. If the water level does not

recede, or goes up, reference the Troubleshooting section.

8) If the water level is receding from the tank you can then advance the controller back to the treated water (C0)

position by pressing SET and the UP buttons simultaneously to advance the controller to the C0 position.

9) Before loading salt add enough water back to the brine tank to cover the salt grid by approximately one (1) inch.

Then add initial salt ﬁ ll to brine tank, and one cup full of unscented laundry bleach to the brine well.

10) Put softener through a complete regeneration - to sanitize the system before use (refer to previous section for

instructions on manual regeneration).

11) Finally, after the regeneration is complete, turn on a faucet plumbed after the water conditioner. Run the faucet

until the water runs clear.

Installation is now complete, and your water softener is now ready for service!