Owner's manual

Installation Instructions for the Window Retractable Awning

MODEL - MESA

TYPE - MANUAL WINDOW RETRACTABLE AWNING

USE - RESIDENTIAL AND COMMERCIAL

CAUTION: THE ARM IS SPRING LOADED. IMPROPER HANDLING CAN RESULT IN SERERE

INJURY TO THE PERSON AND MAY CAUSE DAMAGE TO THE PROPERTY.

W – WIDTH OF THE AWNING (top)

H - HEIGHT OF THE AWNING (Arm radius)

P – PROJECTION & THE ARM

Space – the distance between the projection arms

installation distance

(space) between the

projection arms

PAGE 1
Installation Instructions for the Window Retractable Awning MODEL TYPE USE - MESA MANUAL WINDOW RETRACTABLE AWNING RESIDENTIAL AND COMMERCIAL CAUTION: THE ARM IS SPRING LOADED. IMPROPER HANDLING CAN RESULT IN SERERE INJURY TO THE PERSON AND MAY CAUSE DAMAGE TO THE PROPERTY.
PAGE 2
Hardware required: Type of hardware provided for the following types of structures: Brick and Mortar or any 2” thick structure ****Hardware is not provided for any other types of structures**** Recommended hardware for other wall types: Butterfly or Toggler anchors Tools required: High speed drill, 10mm socket/wrench, 9mm masonry drill bit, Phillip screw driver, level, tape measure and a hammer, pencil Installation: Installation of the top of the awning: images 2 and 3 2
PAGE 3
Installation of the projection arms: image 3 & 4 Measure the height of the awning. The height represents the length of the projection arms. The bracket of the projection arm has a slit and the slit must face the ground. The installation space between the arms must be equal to the (Space, 1st image). Once the arms are installed then lift one arm at a time and attach it to the projection rod of the awning and secure it tightly. Then repeat the same for the second arm. CAUTION: THE ARM IS SPRING LOADED.