Installation Guide

7. Screw the eye end onto the Arm (repeat on other arm).
8. Thread T connector onto arm pipe.
9. Measure 36" down from head rod on each side of awning and attach
camelback hinges to wall making sure arms are straight when viewed from
front. Decreasing this dimension will increase the awnings projection from
wall to clear door openings if desired.
10. Remove middle screw on the camelback hinge.
11. Attach eye ends side of arm pipe to wall mounted camelback hinges.
12. Put arm pipe through hole in fabric.
13. Tread on finial pipe.
14. Thread finial on to finial pipe.
15. Straighten the Front bar; making sure the awning is level and straight.
16. For Optional Pulley:
a) Install tie down cleat on the side with the two pulleys. (4-6” below
the bottom of the awning)
b) Tie one end of the pull cord to the left front bar of the awning, thread
C
M
M
N
E
E