Installation Guide
11. 
For Optional Pulley:
Install tie down cleat on the side with the two pulleys. (4-6” 
below the bottom of the awning) 
(a) 
Tie one end of the pull cord to the left front bar of the awning, thread 
through left side pulley, then over closet right side pulley and down to 
the cleat and back up to open right pulley, tie the end of pull cord to 
the right and left side of the front bar. Draw all slack in pull cord towards 
cleat and tie off. (Shown Below)
Product Care and Maintenance
We use only quality fabrics in the manufacturing of our products, but fabrics do 
have a few limitations; therefore proper care of your awning is important to 
extend its life.
 
Clean awning fabric with a mild soap solution as needed (every 3 
months), rinse thoroughly with water and allow to air dry (never put 
fabrics in your dryer).
 
Keep the underside of your awning clean by brushing with a household 
broom.
 
Remove awning during extremely windy or cold weather to avoid damage to 
the awning.
 
Treating your awning with a marine grade fabric cleaner and fabric guard will 
help increase its life.
 
It’s advisable to remove your awning in the winter to increase its life 
expectancy.
 
Store awning in a dry area. DO NOT store in a non-breathable plastic bag.
 THE DON’T'S
Don’t spray insect repellant over fabric, some solutions may cause 
staining.
Don’t permit leaves, twigs, and pine needles to accumulate and 
remain on the awning.
Don’t drag on abrasive surfaces.
Don’t wash with abrasive cleaners or bleaches for cleaning.






