Specifications

LR-2000 Manual V1.4 Page 3 of 20
1.3 SUGGESTED APPLICATIONS
• Automated vehicle identification for small cars, big trucks and trailers, and railcars.
• Operation of vehicle gates and garage doors for authorized vehicles.
• Tracking material assets in containers and on pallets.
• Hands-free operation of doors and elevator call buttons for handicapped users (wheelchairs, gurneys).
• Data collection using encoded cards and tags for input.
2 SPECIFICATIONS
2.1 LR-2000 READER
Input voltage: Between +7 volts DC and +15 volts DC
Input current (peak): At 7 volts DC......................................... 1.5 amperes
At 12 volts ............................................. 900 milliamperes
At 15 volts ............................................. 700 milliamperes
Read distance (guaranteed): With UHF tags and cards....................... From reader to 10 or 15 feet, depending upon tag type
Frequency: Transmitter ............................................ 902 MHz to 928 MHz
Receiver................................................. 902 MHz to 928 MHz
Frequency-hopping channels: Number of channels............................... 50 channels (U.S.A. standard)
Channel spacing..................................... 500 kHz
Hopping sequence.................................. Pseudo-random pattern of channels
Output data interfaces: Wiegand electrical protocol, and RS-232 serial (simultaneous)
Reader housing: Molded ABS plastic, on 1/8 inch aluminum back-plate; beige color
Environment: Temperature for 100% duty cycle ......... -31 to 113 F (-35 to 45 C)
Temperature for 50% duty cycle ........... -31 to 150 F (-35 to 65 C)
Operating humidity................................ 0% to 95%, non-condensing
Protection from weather Gasket at edge of cover, grommet at cable entrance
(Use shield or housing when required.)
2.2 CABLE EXITING FROM LR-2000 READER
The cable that is integrated into the LR-2000 is 22 gauge, 10 conductors, stranded wire, color-coded insulation, not twisted pairs,
overall 100% shielded, 30 inches long. (The connectors on the reader’s cable, when shipped, have no practical use. The installer
removes these connectors and strips the insulation.)
Color assignment:
Red......................... DC power, positive
Orange ................... RS-232 interface, Transmit Data (Connect to controller’s Receive Data.)
Yellow ................... Enable RF transmission (Connect to reader’s black wire for arming.)
Green ..................... Wiegand interface, Data-0
Blue ....................... Data-Common (For either Wiegand or RS-232 interface. Do not tie to black wire.)
Violet ..................... RS-232 interface, Receive Data (Connect to controller’s Transmit Data.)
Brown .................... (not used)
Black...................... DC power, negative (Do not ground.)
White ..................... Wiegand interface, Data-1
(No insulation)....... Drain wire (Connect to shields of extended cables. Do not ground.)
2.3 EXTENDED CABLE FROM READER TO PANEL AND POWER SUPPLY
The LR-2000 reader requires cables with particular specifications. If the installation will use separate cables from the reader
to the power supply, and from the reader to the reader input panel, use these specifications –
Power cable
: 18 gauge, 2 conductors, stranded wire, color-coded insulation, overall 100% shielded, high quality.
Data cable
: 22 gauge, 3 conductors, stranded wire, color-coded insulation, not twisted pairs, overall 100% shielded, high quality.