User's Manual

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device , pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment
This device complies with Industry Canada license-exempt RSS standard(s): Operation
is subject to the following Two conditions:
this device may not cause interference, and
This device must accept any interference, including interference that may cause
undesired operation
of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillage radioélectrique subi, même si le
brouillage est
susceptible d'en compromettre le fonctionnement.
The information listed above provides the user with information needed to make him or
her aware of a RF exposure, and what to do to assure that this radio operates within the
RSS-102 exposure limits of this radio.
Output power listed is rated conducted. This device must be restricted to work-related
operations only in an Occupational/Controlled RF exposure environment and must
operate with a duty factor not exceeding 50%. The device complies with RF
specifications when the device used at 120 cm from your body. All qualified end-users of
this device must have the knowledge to control their exposure conditions and/or
duration to comply with occupational/controlled Exposure limit and requirements. A
label, as described in this filing, must be displayed on the device to direct users to
specific training information for meeting occupational exposure requirements.
Warning! :This radio is designed for and classified as “Occupational Use Only,”
meaning it must be used only during the course of employment by individuals aware of
the hazards and the ways to minimize such hazards. This radio is NOT intended for use
by the
“General Population” in an uncontrolled environment.