User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Appendix A – Awarepoint Bridge Web Interface 70
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Appendix A – Awarepoint Bridge Web Interface
The Bridge has a simple interface that is accessed by typing in the Bridge’s IP address
into a web browser. This interface can only be accessed if you are on the local
network. You will not be able to access the Awarepoint Bridge Web Interface from an
Internet connection.
Figure 94- Awarepoint Bridge Web Interface
Username: bridgeadmin
Password: last six digits of the Bridge’s MAC address.
Figure 95 - Awarepoint Bridge Password Prompt Dialog Box
You may also view the Bridge statistics using this web interface.