User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #7 – Associating the Tags with Assets 56
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
2. Change the asset attribute to “out of service,” then the Apply button.
3. Find the asset again by using the “out of service” attribute.
4. Choose the Edit button for the asset. The Delete button is now available.