User's Manual

Step #2 – Preparing for Installation 18
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Note: Do
NOT
 Static IP Address, Default Bridge, and Subnet Mask for Ethernet Interface
give this password to anyone without the consent of the
Vice President of Professional Services.
 IP address of Primary and Backup DNS Awarepoint Appliance
 Location
– 1RU in a standard EIA-310-D rack with front and rear rails,
– with power - one (1) NEMA 5-15R power receptacle, and
– one Ethernet port
3. Awarepoint Bridge
 IP Addressing: DHCP or Static. If using Static addressing then: IP
Address, Default Gateway, and Subnet Mask.
 IP Address of Awarepoint Appliance
 Location, with an Ethernet port that has been tested and configured to
work with 10 Base-T, half duplex Ethernet. ( A 10/100 autosense setting
should be adequate)
For B2 installation
4. List of Assets to be Awarepoint Tagged
: Auto-negotiation and 100/Full besides 10/Half can
be configured.
5. List of Computers to install Searchpoint and Infopoint shortcut(s) on
Alternatively, if the customer has a portal used for accessing approved
programs and/or URLs, the Searchpoint and Infopoint URLs need to be
submitted for approval to be added to the portal.
6. Accuracy Testing Plan
7. Delivery Confirmation Form
4.4 What to Bring for an Installation - Checklist
For any system installation, you will need a laptop with the following:
▪ Teraterm software
▪ System Manager
▪ USB to Serial Adapter (if computer doesn’t have a serial port)
▪ Ethernet Cable and Hub
▪ Network Analyzer Tool
You will also need paper maps of each area and the IP addresses for each Bridge (if
the customer requests the Bridges be configured to have a static IP).