User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #1 – Configure Regions 10
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Figure 12 - Open Image Dialog Box
Choose the Open button to select the image.
3.2.5 Creating a Region for a Floor
The Awarepoint Appliance will only compute locations inside areas. Therefore, the
entire floor must be covered with contiguous areas if you want Tags to be positioned on
the floor. You may either draw in multiple areas or draw one area to cover the entire
floor.
Areas may be created with either the Rectangular Area tool or the Polygonal Area tool.
Select the floor you created and choose the Rectangular Area button:
Figure 13 - Floor Image Loaded
To create a new area, draw an area surrounding the entire floor. (You could also draw
any part of the area with the rectangular tool, if the shape permits.)