User's Manual

28
Vaccines for Children |
Installation and Setup Guide
For non-BLE tags, sends a probe reading to Infopoint every 15 minutes
o Probe Sample BLE Interval (seconds) – should be set to 150
For BLE tags, sends a probe reading to awareHealth every 2.5
minutes
Additionally, this BLE blink is used by the Display to establish a
connection between the Tag and Display.
5. Click Submit it you made any changes.
Once a Tag has been brought online and configured, any configuration settings
changes will be sent at the Config Interval time (in seconds). If a configuration setting
change needs to be applied sooner than the set interval, power cycle the Tag by
removing the batteries and then replacing them. When the Tag powers back on, it will
take on the current settings.
4.3.4.2 Placing the Device on a Map
In the absence of BLE beacons for a non-MSE deployment, tag and VFC display
placement are done through System Manager by placing the devices on a map during
installation. Perform the following procedure to place the Tag and Display on a map:
1. In System Manager, click the Devices tab and then select Device Map.
A device region manager list displays.