User's Manual

10
Vaccines for Children |
Installation and Setup Guide
The devices are paired and now display as paired in the Device Pairings
window.
4.2.2 Unpairing Devices
1. From the Device Pairings window, locate the devices you want to unpair.
2. On the far right of the row with the devices you want to unpair, click the Unpair
button.
The devices are now unpaired and show as eligible to be paired in the Device
Pairings window.
4.3 Powering On and Provisioning Devices
VFC requires the powering on and provisioning of both hardware devices, the
Environmental Tag and the Display. Perform the following procedures for each
hardware device.
4.3.1 Environmental Tag Battery and Probe Installation
Perform the following procedure to power on the Environmental Tag:
1. Remove the top casing by squeezing the label sides of the tag and pulling up.
2. Pull off the casing, being careful not to pry it up from the non-sensor end.