User's Manual

7
Vaccines for Children |
Installation and Setup Guide
4 VFC Setup Procedures
Setting up the VFC tag and display unit is a multi-step process. In general, the
procedures are:
1. In System Manager, batch create the Environmental Tag and VFC display units.
This step also includes checking the tag and display configuration parameters.
2. In System Manager, pair the tag and display.
3. Power on and provision the tag.
The tag must be powered on first, begin communicating with Infopoint, then the
display can be powered on.
4. Power on and provision the display.
This should be done within 5 minutes of powering on and provisioning the tag.
5. In System Manager, place the tag and display on a map.
6. In Infopoint (or awareHealth), associate the tag with an asset.
7. In Infopoint (or awareHealth), set an alert for when the temperature-controlled
unit goes out of range.
4.1 Batch Creating Devices
The following procedure is done while in System Manager.
1. From the Devices tab drop-down, select Create.
The Batch Create screen displays.