User's Manual

2
Copyright
Copyright 2008 Awarepoint Corporation
All rights reserved. This product or document is protected by copyright and
distributed under licenses restricting its use, copying, distribution, and decompilation.
No part of this product or document may be reproduced in any form by any means
without prior written authorization of Awarepoint and its licensors, if any.
Awarepoint, the Awarepoint logo, and Real-time Awareness Solution, are trademarks or
registered trademarks of Awarepoint Corporation in the United States and in other countries.
FCC Compliance
Awarepoint Bridge model B2 FCC ID: UAG-B2
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this Device may not cause harmful interference and (2)
this Device must accept any interference received, including Interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
CAUTION: This manual describes installation procedures for electrical
equipment. Proper
precautions are required. Particular attention should be given
to text highlighted with the following symbol:
Antenna Used:
This device has been designed to operate with the antenna listed below, and having a
maximum gain of 2 dBi. Antennas not included in this list or having a gain greater than 2
dBi are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
Pulse W1030
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial envir onment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Awarepoint Bridge model B2 © 2008 Awarepoint Corporation
Installation Manual