User`s manual

7
(2) PS/2 Mouse & PS/2 Keyboard Connector: KB
The connectors are for PS/2 keyboard and PS/2 Mouse.
(3) USB Port connector: USB1, UL1
The connectors are 4-pin connectors that connect USB devices to the system board.
(4) LAN Port connector: UL1
This connector is standard RJ45 connector for Network.
The USBLAN1 support 10M/100Mbps data transfer rate.
(5) Audio Line-In, Lin-Out, MIC Connector:
SURROUND1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC
Line-out: (GREEN)
Audio output to speaker
Line-in: (BLUE)
Audio input to sound chip
MIC: (PINK)
Microphone Connector
(6) Floppy drive Connector (34-pin block): FLOPPY
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(7) Primary IDE Connector (40-pin block): IDE
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
Floppy Drive Connector
Pin 1
FDD
Line-OUT
MIC-IN
Line-IN
PS/2
Mouse
PS/2
Keyboard
COM
VGA
USB1
LAN
USB1