User`s manual

BIOS SETUP
MB860 User’s Manual 39
Integrated Peripherals
This section sets configurations for your hard disk and other integrated
peripherals.
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
On-Chip Primary PCI IDE
Enabled ITEM HELP
Master PIO
Auto Menu Level
Slave PIO
Auto
Master Ultra DMA
Auto
Slave Ultra DMA
Auto
On-Chip Secondary PCI IDE
Enabled
Master PIO
Auto
Slave PIO
Auto
Master Ultra DMA
Auto
Slave Ultra DMA
Auto
On-Chip USB1.1 Controller
Enabled
USB Keyboard Support
Disabled
On-Chip USB2.0 Controller
Disabled
Init Display First PCI Slot
IDE HDD Block Mode Enabled
Onboard Serial Port 3 3E8H
Serial Port 3 Use IRQ IRQ11
Onboard Serial Port 4 2E8H
Serial Port 4 Use IRQ IRQ10
POWER ON Function BUTTON Only
Hot Key Power ON Ctrl-F1
Onboard FDC Controller Enabled
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART Mode Select Normal
RxD , TxD Active Hi,Lo
IR Transmission Delay Enabled
UR2 Duplex Mode Half
Use IR Pins IR-Rx2Tx2
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
EPP Mode Select EPP1.7
ECP Mode Use DMA 3
PWRON After PWR-Fail Off
OnChip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select Enabled to activate each channel
separately.
IDE Primary/Secondary Master/Slave PIO
These fields allow your system hard disk controller to work faster.
Rather than have the BIOS issue a series of commands that transfer to or
from the disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.