User`s manual

BIOS SETUP

IDE Primary/Secondary Master/Slave UDMA

These fields allow your system to improve disk I/O throughput to

33Mb/sec with the Ultra DMA/33 feature. The options are Auto and

Disabled.

Init Display First

This field allows the system to initialize first the VGA card on chip or

the display on the PCI Slot. By default, the PCI Slot VGA is initialized

first.

IDE HDD Block Mode

This field allows your hard disk controller to use the fast block mode to

transfer data to and from your hard disk drive.

Onboard FDD Controller

Select Enabled if your system has a floppy disk controller installed on

the CPU card and you wish to use it. If you install an add-in FDC or the

system has no floppy drive, select Disabled in this field. This option

allows you to select the onboard FDD port.

Onboard Serial/Parallel Port

These fields allow you to select the onboard serial and parallel ports and

their addresses. The default values for these ports are:

Serial Port 1 3F8/IRQ4

Serial Port 2 2F8/IRQ3

Parallel Port 378/IRQ7

UART 2 Mode

This item allows you to determine which Infra Red (IR) function of

onboard I/O chip. The options are Standard, IrDA, and ASKIR.

Parallel Port Mode

This field allows you to determine parallel port mode function.

SPP Standard Printer Port

EPP Enhanced Parallel Port

ECP Extended Capabilities Port

Onboard Legacy Audio

Enable or disable the on board legacy audio with this option.

Sound Blaster

Enable or disable the sound blaster feature with this option.