User`s manual
BIOS SETUP
37
Integrated Peripherals
This section sets configurations for your hard disk and other integrated
peripherals.
CMOS Setup Utility – Copyright © 1984-2000 Award Software
Integrated Peripherals
On-Chip IDE Channel 0
Enabled ITEM HELP
On-Chip IDE Channel 1
Enabled Menu Level
IDE Prefetch Mode
Disabled
IDE Primary Master PIO
Auto
IDE Primary Slave PIO
Auto
IDE Secondary Master PIO
Auto
IDE Secondary Slave PIO
Auto
IDE Primary Master UDMA
Auto
IDE Primary Slave UDMA
Auto
IDE Secondary Master UDMA
Auto
IDE Secondary Slave UDMA
Auto
Init Display First PCI Slot
IDE HDD Block Mode Disabled
Onboard FDD Controller Enabled
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART 2 Mode Standard
UR2 Duplex Mode Half
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
Onboard Legacy Audio 3
SB I/O Base Address 330
SB IRQ Select 10
SB DMA Select
MPU-401
MPU-401 I/O Address
OnChip IDE Channel 0 / 1
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select Enabled to activate each channel
separately.
IDE Prefetch Mode
These field enables/disables the prefetch buffers in the PCI IDE
controller. The prefetch buffers are used as a temporary storage place as
data is transferred from one location to another.
IDE Primary/Secondary Master/Slave PIO
These fields allow your system hard disk controller to work faster.
Rather than have the BIOS issue a series of commands that transfer to or
from the disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select
the best available mode.