Manual

Device Management
91
If “Multiple Address Setting” is selected, the IP addresses of the two Ethernet
ports should be set respectively.
Check “Obtain an IPv4 address automatically”, “Obtain an IPv6 address
automatically” and “Obtain DNS automatically” to get the network addresses
automatically, or manually enter the network addresses; select one NIC card
connected to the Internet as the default route and then click “Apply” to save the
settings.
11.1.2 Port Configuration
Click StartSettingsNetworkPort to go to the interface as shown below.
Enter the HTTP port, HTTPS Port, server port, RTSP and POS port of the DVR,
enable “Anonymous” as required and then click “Apply” to save the settings.
* You can create a private certificate here. Click the “Create” button to create a
private certificate. Enter the country (only two letters available), domain (DVR’s
HTTP Port: the default HTTP port of the DVR is 80. The port number can be
changed to others like 81. The port is mainly used to client remote access. If you
want to access the DVR through a web browser, you should enter IP address
plus HTTP port in the address bar like http://192.168.11.61:81.
HTTPS Port: the default HTTPs port of the DVR is 443.
HTTPs provides authentication of the web site and protects user privacy. How to
use it?
①
Enter IP address plus HTTP port in the address bar of the web browser.
Then enter username and password to log in. Click Functional PanelNetwork
HTTPS to go to the following interface
②
Install a certificate.