Manual

9 Alarm Management

9.1 Sensor Alarm

To complete the entire sensor alarm settings, you should enable the sensor

alarm of each camera and then set up the alarm handling of each camera.

The conﬁguration steps of the above mentioned alarm linkages are as follows.

Duration: it refers to the interval time between the adjacent motion detections.

For instance, if the duration time is set to 10 seconds, once the system detects a

motion, it will go to alarm and would not detect any other motion (speciﬁc to

camera) in 10 seconds. If there is another motion detected during this period, it

will be considered as a continuous movement; otherwise it will be considered as

a single motion.

Record: check it and then the “Trigger Record” window will pop up

automatically (you can also click the “Conﬁgure” button to pop up the window).

Select camera on the left side and then click to set the camera as the trigger

camera. Select trigger camera on the right side and then click to cancel the

trigger camera. Click the “OK” button to save the settings. The trigger cameras

will record automatically when the sensor alarm is triggered.

Snapshot: check it and then the “Trigger Snapshot” window will pop up

automatically. Conﬁgure the trigger camera in the window. The trigger cameras

will snap automatically when the sensor alarm is triggered.

Push: check it and choose ON or OFF. If it is ON, the system will send messages

when the sensor alarm is triggered.

Alarm-out: check it and then the “Trigger Alarm-out” window will pop up

automatically. Conﬁgure the trigger alarm-out in the window. The system will

trigger the alarm-out automatically when the sensor alarm is triggered. You

need to set the delay time and the schedule of the alarm outputs. See 9.5.1

①

Click StartSettingsAlarmSensor Alarm to go to the following

interface.

②

③

④

⑤

Select the alarm type (NO or NC) according to trigger type of the sensor.

Enable the sensor alarm of each camera.

Check the “Record”, “Snapshot”, “Push”, “Alarm-out” and “Preset” and

enable or disable the “Buzzer”, “Pop-up Video”, “Pop-up Message Box” and

“E-mail” as required.

Click “Apply” to save the settings.