Manual

Click StartSettingsDiskStorage Mode to go to the interface as shown

below.

There are four disk groups. By using disk group, you can correspond the camera

to disk (the record data of the camera in the group will be stored into the disks

in the same group). The DVR with e-SATA interface supports e-SATA recording.

The added disks and cameras will be added into group one automatically. The

disks and cameras in the groups can be deleted except group one (select a disk

group and then click on the top right corner of the added disk or camera to

delete it from the group). The deleted disks and cameras will be moved into

group one automatically.

Each group can add the disks and cameras from other groups. Each disk and

camera can only be added into one normal group. Select a disk group and then

click in the disk or camera row to pop up a window. Check the disks or

cameras in the window and then click “Add”.

Some models may support “Backup Group”. If your device doesn’t support this

function, please skip the following instructions.

7.5.1 Storage Mode Conﬁguration

Record & Disk Management