Manual

Live View Introduction

Click StartSettingsSystemBasicOutput SettingsMain Output to go to

the interface as shown below.

Area ① displays all the dwell schemes; area ② shows the detailed information of

the scheme; area ③displays all the cameras; area ④ is the tool bar ( : clear

button; : favorite button, click it to pop up a window, enter the display mode

name in the window and then click “OK” to save the current display mode; other

buttons are screen mode buttons).

Go to the live view interface and then click to pop up a little window. Set the

dwell time in the window and then click to view the live group by group

according to the camera number of the current screen mode. Double click the

sequence view interface to pause the view; double click again to restore the

view. Click to stop the view.

5.2.3 Scheme View In Sequence