Manual

Device Management
102
11.1.13 SNMP (Optional)
①
Click StartSettingsNetworkSNMP to go to the interface for SNMP
configuration.
③
②
④
⑤
Check SNMPv1or SNMPv2 to enable this function.
Set the port of the SNMP.
Set the trap address and the trap port.
Click “Apply” to save the settings.
Trap Address: The IP address of SNMP host.
Trap Port: The port of SNMP host.
Tips: Before setting the SNMP, please download the SNMP software and
manage to receive the device information via SNMP port. By setting the trap
address, the device is allowed to send the alarm event and exception message
to the monitoring center.
11.1.14 View Network Status
Click StartSettingsNetworkNetwork Status to view the network status or
click on the tool bar at the bottom of the live view interface to view network
status conveniently.