User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 Wizard & Main Interface
- 4 Camera Management
- 5 Live Preview Introduction
- 6 PTZ
- 7 Record & Disk Management
- 8 Playback & Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Compatible Device List
PTZ
DVR User Manual
46
6.4 PTZ Protocol Setting
Click StartSettingsCameraPTZProtocol to go to the interface as shown below. You can
enable or disable the PTZ and set the protocol, baud rate and address of the analog dome in
the interface. Please make sure the analog speed dome camera is well connected to the DVR
before you control it.
Select the camera and enable PTZ and then set the protocol, baud rate and address of the
dome according to the settings of the dome.
Protocol: The default communication protocol of the DVR is COC. Range from: PELCOP,
PELCOD, LILIN, MINKING, NEON, STAR, VIDO, DSCP, VISCA, COC, etc.
Address: The address of the PTZ device.
Baud Rate: Baud rate of the PTZ device. Range from: 110, 300, 600, 1200, 2400, 4800, 9600,
19200, 34800, 57600, 115200, 230400, 460800, 921600.