Manual

11 Device Management
90
11.1 Network Configuration
11.1.1 TCP/IP Configuration
Click StartSettingsNetworkTCP/IP to go to the following interface. Check
“Obtain an IPv4 address automatically”, “Obtain an IPv6 address automatically”
and “Obtain DNS automatically” to get the network addresses automatically, or
manually enter the network addresses. You can modify the MTU value according
to the network condition (MTU, Maximum Transmission Unit, can be modified
according to network condition for higher network transmission eciency). Click
“Apply” to save the settings.

Multiple Ethernet Ports Setting
If the DVR has two network ports or above, you can select the network work
pattern as required.
Network Fault Tolerance:
The two network ports will be bound to one IP address if you select the “Network
Fault Tolerance” pattern. There are many advantages of this work pattern: 1.
increase the bandwidth; 2. form a network redundant array to share the load.
When a failure happens to one network port, the other port will take over the
entire load immediately. The takeover process is seamless and the network
service will not be broken o.
If “Network Fault Tolerance” is selected, check “Obtain an IPv4 address auto-
matically”, “Obtain an IPv6 address automatically” and “Obtain DNS automati-
cally” to get the network addresses automatically, or manually enter the
network addresses; select one Ethernet port as the primary card and then click
“Apply” to save the settings.
Multiple Address Setting: