Manual

Alarm Management
80
9.5.4 Buzzer
Click StartSettingsAlarmEvent NotificationBuzzer to go to the buzzer
configuration interface. Set the delay time of the buzzer and then click “Apply”
to save the setting. You can click “Test” to test the buzzer.
9.5.5 Push Message
Click StartSettingsAlarmEvent NotificationPush Message to go to the
interface as shown below. Check “Enable”, choose the push schedule and then
click the “Apply” button to save the settings. If Push Server is online, it will push
messages to the mobile clients.
9.5.6 Alarm Server
Go to AlarmAlarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server.
Then select protocol. If “Send Heartbeat” is enabled, set the interval times. After
that, test the eectiveness of the alarm server. Having tested successfully,
please click “Apply”. When an alarm occurs, the device will transfer the alarm
event to the alarm server. If an alarm server is not needed, there is no need to
configure this section.