Manual

Alarm Management

②

③

Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”,

“Buzzer”, “Pop-up Video” and “E-mail”. The alarm handling setting of line

crossing alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for

details).

Click “Apply” to save the settings. You can click “Crossing Conﬁg” to go to

the line crossing conﬁguration interface.

9.3.4 Intrusion Detection

Intrusion Conﬁguration:

①

②

③

④

⑤

⑥

Click StartSettingsCameraIntelligent DetectionIntrusion Detec-

tion to go to the following interface.

Select the camera, enable the intrusion detection and set the duration.

Select the alarm area. Up to 4 alarm areas can be set up.

Draw the alarm area of the intrusion detection. Refer to the interface as

shown below. Check “Draw Area” and then click around the area where you

want to set as the alarm area in the image (the alarm area should be a closed

area). Uncheck the “Draw Area” if you ﬁnish the drawing. Click the “Clear” button

to delete the alarm area.

Click “Apply” to save the settings.

Click “Processing Mode” to go to the alarm handling conﬁguration inter-

face of intrusion detection.

Alarms will be triggered if someone or something intrudes into the pre-deﬁned

area.