Manual

12 Remote Surveillance
108
12.1 Mobile Client Surveillance
①
②
③
④
Click StartSettingsAlarmSensor Alarm to go to the following
interface.
Download and install the mobile client “SuperLive Plus” into the mobile
device with the Android or iOS system.
Run the mobile client, go to the “Add Device” interface and then click to
scan the QRCode of the DVR (Go to StartSettingsSystemInformation
Basic to view the QRCode of the DVR).
After scanning the QRCode successfully, enter the login password to log in
mobile client.
12.2 Web LAN Access
①
②
Click StartSettingsNetworkTCP/IP to go to the “TCP/IP” interface.
Set the IP address, subnet mask, gateway, preferred DNS and alternate DNS of
the DVR.
Open a web browser on your computer, enter the IP address of the DVR in
the address bar and then press enter to go to the login interface as shown
below. You can change the display language on the top right corner of the login
interface. Enter the username and password of the DVR in the interface and then
click “Login” to go to the live view interface.