Quick Start Guide

The ﬁrst time you run the NVR, you will be required to set your password immediately in

order to protect your privacy.

Please be sure to record your username and password and save them in a secure place. If

you forget your password, you will be unable to login the system, please contact your

reseller to reset the password.

Connection Diagram

1 NETWORK VIDEO RECORDERS | AVR SERIES

NOTE: Above diagram is for reference only. The practical connection may be different

depending on the NVR you purchased.

1) You can connect to other IP cameras remotely over the Internet.

2) Connect a CAT.5E or higher RJ45 Ethernet cable for local connectivity. You can connect

to other IP cameras through your local network.

3) Two-way voice conversation with the remote PC.

4) Connect an external hard disk drive to backup ﬁles stored on the NVR.

5) Connect the included power cable (48V/2A, 4-Pin DIN connector).

6) Use the USB ﬂash disk for backup, camera, or system upgrade.

7) Connect a RS-485 device such as speed dome camera.

8) Connect an external alarm output device such as siren.

9) Connect external alarm sensors.

10) Connect the video output of the NVR to the TV or monitor via HDMI or VGA connection.

11) Connect speakers if you want to listen to the live audio sound or audio playback from the

NVR.

12) Connect the PoE IP cameras. It may take up to 1 minute for the cameras to start

transmitting video to the NVR.