User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 Wizard & Main Interface
- 4 Camera Management
- 5 Live Preview Introduction
- 6 PTZ
- 7 Record & Disk Management
- 8 Playback & Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Compatible Device List
Wizard & Main Interface
DVR User Manual
16
④ QRCode. Enable the NAT function in the interface or set it in the network configuration
after exiting the wizard (please refer to 11.1.7 NAT Configuration for details). You can scan the
QRCode through mobile client which is installed in the mobile phone or PAD to log in the
mobile client instantly. Please refer to 12.1 Mobile Client Surveillance for details.
⑤ Add Camera. Click “Refresh” to refresh the list of online IP cameras which are in the
same local network with DVR and then click to add the searched camera. Click “Add
All” to add all the cameras in the list. Click to delete the added camera. Click “Delete
All” to delete all the added cameras.
Click to edit the searched IP camera as shown on the below left. Input the new IP address,
subnet mask, gateway and the password of the camera. You can check “Sync to IPC” to modify
the IP address of the IPC via different network segments for being in the same network
segment with the DVR. Click “OK” to save the settings.