User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Basic Operation Guide
- 3 Wizard & Main Interface
- 4 Camera Management
- 5 Live Preview Introduction
- 6 PTZ
- 7 Record & Disk Management
- 8 Playback & Backup
- 9 Alarm Management
- 10 Account & Permission Management
- 11 Device Management
- 12 Remote Surveillance
- Appendix A FAQ
- Appendix B Calculate Recording Capacity
- Appendix C Compatible Device List
Record & Disk Management
DVR User Manual
43
7 Record & Disk Management
7.1 Record Configuration
7.1.1 Mode Configuration
Please format the HDDs before recording (refer to 7.5 Disk Management for details). Click
StartSettingsRecordMode Settings to go to the mode settings interface. You can set the
record time under the “Manual Record Settings” and then click “Apply” button to save the
settings. There are two record modes: auto mode and manual mode.
Auto Mode
Motion Record: Motion alarm record will be enabled when motion alarm happens.
Sensor Record: Sensor alarm record will be enabled when sensor alarm happens.
Motion Record+Sensor Record: Motion/sensor alarm record will be enabled when
motion/sensor alarm happens.
Always(24
ⅹ
7) Record+Motion Record: Normal record is enabled all the time; motion alarm
record will be started when motion alarm happens.
Always(24
ⅹ
7) Record+Sensor Record: Normal record is enabled all the time; sensor alarm
record will be started when sensor alarm happens.
Always(24
ⅹ
7) Record+Motion Record+Sensor Record: Normal record is enabled all the time;
motion/sensor alarm record will be enabled when motion/sensor alarm happens.
Select one auto mode to pop up the corresponding window. Set the encode, resolution, FPS,
bitrate type, quality, max bitrate and audio of each camera and then click “OK” to save the
settings. Please adjust the parameters according to the actual condition.