User Manual

Device Management
DVR User Manual
83
11 Device Management
11.1 Network Configuration
11.1.1 TCP/IP Configuration
Click StartSettingsNetworkTCP/IP to go to the following interface. Check “Obtain an
IPv4 address automatically”, “Obtain an IPv6 address automatically” and “Obtain DNS
automatically” to get the network addresses automatically, or manually input the network
addresses. You can modify the MTU value according to the network condition (MTU,
Maximum Transmission Unit, can be modified according to network condition for higher
network transmission efficiency). Click “Apply” to save the settings.
11.1.2 Port Configuration
Click StartSettingsNetworkPort to go to the interface as shown below. Input the HTTP
port, HTTPS Port, server port and RTSP port of the DVR, enable “Anonymous” as required
and then click “Apply” button to save the settings.